Free GCSE Geography River Landforms Cover Lesson (AQA, No Tech)

A complete print-and-go AQA GCSE Geography cover lesson on river landforms. It includes a supervisor script, a student information sheet, questions, an exam-style 6-mark task and a mark scheme that a non-specialist can use.

This is a whole cover lesson you can print. It is written for Year 10 or 11 classes on the AQA GCSE Geography (8035) course, Paper 1, Section C: Physical landscapes in the UK, river landscapes option. It takes about 60 minutes. It needs no slides or computers, and nobody has to teach it. A cover supervisor with no Geography background can run it from the first section.

Copy each section below onto its own page. Before you print, check the facts against your class textbook. Specifications and textbooks use slightly different wording, so change the key terms to match what your students have been taught.

What to print (per student): the information sheet, the task sheet and lined paper. For the supervisor: the script and the mark scheme. Keep the mark scheme on the supervisor's copy only.

Page 1: Cover supervisor script (60 minutes)

Before students arrive: put the information sheet and task sheet on each desk, face down. Write on the board: "River landforms: read, answer, then exam question. Silent individual work."

  1. 0–5 min: Settle and register. Say: "Today's work is set by your Geography teacher. It's exam practice for Paper 1. Work on your own and in silence. Everything you need is on the sheets."
  2. 5–20 min: Reading. Say: "Turn over the information sheet. Read it all and underline every key term in bold. You have 15 minutes." Walk the room. Anyone who finishes early can start Task A.
  3. 20–35 min: Task A (knowledge check). Say: "Answer the questions in full sentences. Use the information sheet." Students may use it.
  4. 35–40 min: Task B (sequence the diagram). Short and quick to finish.
  5. 40–55 min: Task C (6-mark exam question). Say: "This is exam conditions. Turn the information sheet face down. You have 12 minutes to plan and write." At 52 minutes say: "Three minutes left."
  6. 55–60 min: Self-check and collect. Read out the "What a good answer includes" list from the mark scheme. Students tick each point they included in a different colour. Then collect the task sheets and any lined paper, with names on everything.

Behaviour notes: reading in silence is the hardest part for some students. If someone says "we haven't done this", reply: "Do your best from the sheet. Your teacher wants to see what you can work out." Do not let students work in pairs on Task C.

Leave for the teacher: a list of absent students, anyone who did little or no work, and any questions students kept asking.

Page 2: Student information sheet

How rivers shape the land

Rivers erode, transport and deposit material. Erosion happens through four processes:

In the upper course, vertical erosion is dominant: the river cuts down into its bed. In the middle and lower course, lateral erosion (sideways erosion) and deposition become more important.

Waterfalls and gorges (upper course)

A waterfall forms where a band of hard (resistant) rock lies on top of soft (less resistant) rock. The soft rock erodes faster, so a step forms in the river bed. As water falls over the step, hydraulic action and abrasion erode the soft rock underneath. This creates an overhang of hard rock. Swirling water and rocks wear out a deep plunge pool at the bottom. In time the overhang has nothing holding it up and it collapses. The fallen rocks add to abrasion in the plunge pool. Each collapse moves the waterfall a little further upstream. Over thousands of years this retreat leaves a steep-sided valley called a gorge.

Example: High Force on the River Tees in County Durham. Here the river drops around 21 metres over a hard layer of igneous rock called the Whin Sill, which lies above softer rock layers. A gorge has formed downstream of the falls as the waterfall has retreated.

Meanders and ox-bow lakes (middle and lower course)

A meander is a bend in a river. Water flows fastest on the outside of the bend, where the channel is deeper. This causes lateral erosion and forms a steep river cliff. On the inside of the bend the water is slower and shallower, so it loses energy and deposits sand and gravel. This builds a gently sloping slip-off slope.

Over time erosion on the outer bends brings two bends closer together, and the neck of the meander gets narrower. During a flood the river may cut through the neck. Water then takes the shorter, straighter route. Deposition seals off the old bend, which leaves an ox-bow lake.

Floodplains and levees (lower course)

A floodplain is the wide, flat land on either side of a river that floods. When the river spills over its banks, the water slows down and loses energy, so it deposits sediment (alluvium). The coarsest, heaviest material is dropped first, right next to the channel. After many floods this builds raised banks called levees. Finer material is carried further and spread across the floodplain.

Key terms to learn

Vertical erosion · lateral erosion · hydraulic action · abrasion · overhang · plunge pool · gorge · river cliff · slip-off slope · neck · ox-bow lake · floodplain · levee · deposition

Page 3: Student task sheet

Task A: Knowledge check (use the information sheet)

  1. Define lateral erosion. (1 mark)
  2. Describe the difference between abrasion and attrition. (2 marks)
  3. Explain why a waterfall needs both hard and soft rock to form. (2 marks)
  4. Explain why water deposits material on the inside of a meander bend. (2 marks)
  5. Name a UK waterfall and the river it is on. (1 mark)
  6. Explain why the coarsest sediment is deposited closest to the river channel during a flood. (2 marks)

Task B: Sequence the formation of an ox-bow lake

Put these stages in the correct order (write the letters):

Extension: draw a labelled sketch for each stage.

Task C: Exam-style question (information sheet face down)

Explain how a waterfall and gorge are formed. Use a labelled diagram in your answer. (6 marks)

Planning tip: think in this order: rock types, then erosion processes, then overhang, then collapse, then retreat, then gorge.

Page 4: Mark scheme (supervisor/teacher copy)

Task A answers

  1. Erosion that wears away the sides (banks) of the river channel (sideways erosion).
  2. Abrasion is the load scraping or grinding against the bed and banks (1). Attrition is pieces of load knocking into each other and becoming smaller and rounder (1).
  3. The soft rock erodes faster than the hard rock (1), so a step or overhang forms where the hard rock is left sticking out (1).
  4. The water is slower and shallower on the inside bend (1), so it has less energy and cannot carry its load (1).
  5. High Force, River Tees (accept other correct UK examples the class has studied).
  6. When the water leaves the channel it slows down and loses energy (1). Heavy material needs the most energy to carry, so it is dropped first (1).

Task B answer

D, B, E, A, C

Task C: Levels mark scheme (6 marks)

This follows the levels structure GCSE Geography uses for extended answers. It is an original question written in that style. It is not a past-paper question.

What a good answer includes (read this out for self-checking)

How to adapt this lesson in five minutes

Quick checklist before you leave it for cover

More templates and kits
Browse the Quillwork shop